|
|
Misc Parts
| 1961 Oldmobile 88 RH Fender "Vent" Molding Trim |
$25.00 |
|
| This is a molding that is located on the RH front fender at the outside front edge.
It resembles a vent. The molding is in fair condition with some small pitts.
Nothing is broken and all three studs are intact on the rear for mounting.
Offers considered. Be sure to check my other auctions for more 1961 Oldsmobile
parts. I have a lot of parts left over from a restoration.
If you have any questions, email vettman@corvettecruising.com
or call me @ 314-520-9441. Don.... |
|
More Photos and Information
Contact Us / Make Offer
|
| 1961 Oldmobile LH Rear of Quarter Molding....MINT! |
$45.00 |
|
| This is a molding that is located just above the LH taillight at the back
edge of the quarter panel. This molding is in mint condition. All you need
to do is put it on your car. Even includes one factory original clip. This
will beautify the rear of your Olds!
Offers considered. Be sure to check my other auctions for more 1961 Oldsmobile
parts. I have a lot of parts left over from a restoration.
If you have any questions, email vettman@corvettecruising.com
or call me @ 314-520-9441. Don.... |
|
More Photos and Information
Contact Us / Make Offer
|
| 1961 Oldsmobile RH rear of quarter molding |
$45.00 |
|
| This is a molding that is located just above the RH taillight at the back edge of the quarter panel. This molding is in mint condition. All you need to do is put it on your car. Even includes two factory original clips. The clips are no longer available at GM or any aftermarket supplier that I can find.
This will perk up the rear of your Olds! ... |
|
More Photos and Information
Contact Us / Make Offer
|
| 1961 Oldsmobile Windshield Molding, RH |
$27.50 |
|
| This is a RH windshield molding. It is in excellent condition with one small
ding at the base of the molding. The molding has an excellent shine. Looks very good.... |
|
More Photos and Information
Contact Us / Make Offer
|
| 1989 GMC Front Sway Bar |
$35.00 |
|
| This is the large 1 1/8" sway bar used on half ton pickups. Came off a shortbed we hot rodded. This would be a great addition to your upgraded pickup. If you changed from a 6 cyl to a V-8, you MUST have this part!
Applications include all 1988 to 1998 Chevy and GMC Pickups.
Shipping is $25.00 to the continental US.... |
|
More Photos and Information
Contact Us / Make Offer
|
| Fan, 12 V, Mobile |
$25.00 |
|
| This is a 12 volt fan that is perfect for your big rig truck, camper, or van. It has two speeds, and works perfectly. No loose bearings, etc. The fan is 7-1/2" diameter on the cage. It takes a 2-1/2 inch flat area for mounting it. It is small enough to mount most anywhere: dash, roofline, rear area of camper or van, etc. The fan is made by Hupp Inc, Mobile Products Division out of Cleveland, Ohio.
I bought this fan back when the van phase was going strong. We used them when we went camping in the van. Yeah, I know, showing my age. Looks good as it is. The chrome is not pitted, and the blades are straight with no damage. With... |
|
More Photos and Information
Contact Us / Make Offer
|
| Water Outlet, Mr. Gasket, New, Chevy V-8, 1955 to 1965, Chrome Plated |
$15.00 |
|
| This is an unused Water Outlet designed to fit Cheverolet Cars from 1955 to 1965 with the center outlet on the water outlet. It is brand new. I unwrapped it to take pictures only. It comes with a new rubber seal, and two chrome bolts to install.
The chrome is excellent condition and is ready to install and beautify your Chevy V-8. Shipping will be $5.50 flat rate to the continental US. No foreign orders.
... |
|
More Photos and Information
Contact Us / Make Offer
|
|
|
