Note: These are replacements that look exactly like the originals, except that they do not have the "C" with the line through them. They instead have an "S" on the head. Otherwise, they are the same appearance. We always recommend chasing the threads in the trunk and deck with a cleaning tap (1/4-20 thd.) prior to installing. It will make your installation go much easier. It is also a good idea to use a good "anti-seize" compound on the threads...

We are selling these in lots of 20 screws.

Shipping will be $5.79. ...

We sell them in Lots of 20 pieces. This quantity will give you plenty for various uses. These will never rust because they are Stainless Steel!

Shipping is $5.79 Priority Mail.

We have access to many old fasteners. If you are having trouble finding one, send me a sample and I will most likely be able to find it for you. I have a big supply of speciality fasteners we use in ...

These are used on the front end of virtually every Chevrolet made in the 60's. They are the correct length with the captured washer.

Black anodized and ready to make your restoration fresh. Don't waste your time trying to wire brush, and clean the threads on the old ones, when you can just bolt in new ones. These are exactly the same size as the GM originals.

Sold in lots of 20 pieces. Shipping is $5.79. ...

If you want show quality finish, you can do them yourself or we will polish them on our high speed polisher for an additional $4.00 per set. The closeup shows a polished bolt.

Shipping will be $6.00. ...

Some early Corvettes (53-62) use two per door. Other cars only used one. The Corvettes have an additional lock operating rod that also uses this clip.

Shipping via US Postal Priority Mail is $6.00. ...

Packaged four to a set. If you need to stock up on them, we have plenty on hand!

These are exact replacements for your car. The early cars (56-63) used a slightly different clip. We also stock those. The only real difference is the corners on the older ones are squared off.

Shipping will be $6 through the US Post Office Priority Mail. Additional ...

We are selling these in lots of 10. This is the perfect amount to redo all four cables on both ends (assuming you have AC), and also to redo the fresh air vents on your car.

You can check the Heater Control restoration by clicking HEATER CONTROL RESTORE". There are a co...

Sold in lots of 26. You may want to order two sets to do both front and rear windows.

Shipping will be $6.00 ...

We've all been there. Install a new carpet and tear out the two bottom retainers getting the carpet underneath the steering column plastic carpet retainer around the steering column. Now what? How do I keep it in place?

Well, the best way is to use our GM retainers. Have you replaced your firewall insulation and did not get the retainers? Lost some? Here are the right ones.

These fasteners are designed to fit a 27/64" hole. If you painted your firewall, it is a good bet that with all the primer you used, and then the...

Pricing: One set of two keys (one door and one ignition) $4.49
Two sets of two keys (two door and two ignition) $7.29

Shipping is $6.00 to the US 48 states....

Here is the scenerio.....you are faithfully restoring your muscle car headlight receivers. You bead blasted them and are getting ready for paint. You so very carefully lube the headlight adjusters to try to get them unstuck.......then, Bam! It breaks off.

So, you now try to remove the other ones from the receiver only to find the same problem......the plastic gets very brittle when it gets to say, 40-50 years old!

. Well, quit yer whining and just replace em! This is infinately easi...

These are packaged in sets of four. So you will receive three sets. This is another item that is always in demand, but short in supply when you need them. Put some in your toolbox, so the next time you won't have to run to the parts store again hoping they will have them.

Shipping will be $6.00 for one lot. If you need to order more, each additional lot will cost an additional $1.50 to ship. ...

They are designed to have a break point every 1/16" of an inch, so that you can make them just the right size. I have used these on a 65 Nova SS to attach some lower moldings as well as some early Nova and Chevelle side moldings. Very handy!

If your molding is positioned off center from the hole, these can accomodate that by breaking off the ends in an uneven fashion. By removing more from one side of the clip as compared to...

Sold in lots of 26. You may want to order two sets to do both front and rear windows.

Shipping will be $6.00. Missouri residents add 7.225% tax....

We have packaged these in lots of 10. Most likely, this will take care of your front door handles and front and rear window cranks.

Shipping is $6....

These also give the car a luxury car feel when closing the glove box. No more "clang"! Just very quiet "thunk" when closing the glove box door.

We are selling these in lots of six. Keep spares on hand for other areas that need a small bumper. Have many applications. Shipping will be $6.00 via US Priority Mail. ...

Quit trying to hunt up old rusty ones to put your new door panels on you fresh ride. Give us a call to make you life easier.

Shipping is $6.00 via Priority Mail....